2" Inch 12V DC Brass Electric Solenoid Valve 12 Volt VDC - FREE SHIPPING

About this item

This is a 2-inch brass electric solenoid valve built for water, air, and similar fluid lines. It stays closed until 12V DC power hits the coil, then opens fast — in under a second — and works fine even with zero inlet pressure, so it's good for gravity-fed setups. Brass body, stainless steel components, and a Viton diaphragm give it decent durability across a wide temperature range. Note the coil runs hot if left powered for long stretches, so good ventilation and an inline pre-filter are recommended.

• 2" brass solenoid valve, normally closed, opens when 12V DC power is applied
• 2" FNPT connections, works from 0 to 90 PSI with no minimum pressure needed (gravity feed OK)
• Handles temps from 15°F to 250°F, suitable for water, air and similar media
• Viton diaphragm seal, stainless steel internal parts, 50mm orifice, Cv 45
• Fast acting (under 1 second), polarity doesn't matter, best mounted coil-up
• Draws 40 watts, 5.5" lead wire, weighs 7 lbs, measures 6.5"H x 5.3"L x 4.25"W

Specifications

Brand

Not specified

Voltage

12 Volts DC

Material

Brass

PSI Range

0 - 90 PSI (No Minimum Pressure)

Port Size

2'' Inch

Temp Range

15 – 250F

Operation Type

Normally Closed